How to shorten curtians without sewing? - shorten curtains without sewing
I need to shorten the curtain, but it's not about me, I can sew, cut, or in any way altered permanently. I can not even hem them free because they are made of plastic and foreign tissue, the pinhole camera showed, even after the withdrawal of his son.
I tried not on tape (loud), and Bulldog clips (it was terrible, and not when I am about 15 clips). Has anyone other ideas?
Saturday, January 16, 2010
Shorten Curtains Without Sewing How To Shorten Curtians Without Sewing?
Subscribe to:
Post Comments (Atom)
10 comments:
You can try to type Curtains crown - the artistic and make it attractive, while the solution to your problem :-))
depending on how much extra length is equidistant horizontal folds. You can use these rights at the top make [preferred] or less - what looks good.
Foldback will jointly hold the folds at the end. also a little long, and you get a half-circle at regular intervals. I hope that clear?
and not because, of course, decorate the bulldog clips to do well. You can possibly small origami butterflies, beetles, etc., and glue and tape the video clip. These are as small flowers and birds in their shadows are considered.
As Origami, look at some free artificial or dried flowers [Potpourri, for example] and glue and tape on the clips.
or just a few spots of glue color and size desired.
You can also mirror, waste, woolen tassels, beads, sequins, etc., etc.
Of course, everything must be done taking into account the APscroll through them on the curtains.
Hope this helps
all the best :-)
After careful consideration, are: Why do not the clips on the back of / behind the curtain, rather than transmitted. and that in this way does not achieve the desired reduction. :-))
Is it possible the curtain rod above the window, by increasing the amount to shorten the curtain to? It is much easier at the bar a few inches (or do not raise even six inches) on the curtain to the ceiling!
Who? Have you asked the owner of the curtains can, so they shorten? I would suggest sticking substance, but the ruin curtains. If I were you, I would go to Goodwill or a flea market and buy my own curtains and do what I want!
Let us consider them to hold back and with a tie-back and let the extra fall on his tie.
Or, just repay the loan and reuse a canvas curtain or two.
You can have a little link, or are wrapped around the curtain rod a few times.
Why reduce all?
Raising the Bar --
Configure set higher in the top bar or a rod or tie rod, than you are.
With needles or safety pins.
With needles or safety pins.
Tape
As you point out that the pinhole is unacceptable output pins or safety pins do not work. If we could raise the curtain rod that is to the hem of the curtains when you want it, it would be a good solution. However, if you can not make holes in the wall (for example, if you are a tenant and the landlord is allowed), you can try to register with a special tape.
Hardware stores sell a variety of different bands. They have as a "Gorilla Tape" which is quite difficult, there is a possibility that you are leaving a sticky residue on the curtain, when he was kidnapped, too. This also happens with tape.
Yesterday, at ACE hardware, I noticed a new type of tape used for painting. It is bigger and stronger than regular duct tape and comes in various colors and transparent. Depending on how the heavy curtain, you can use any color. Tape leaves no sticky residue on the lower hem of the curtains removed.
After removing the tape and the lowerHem, perhaps through a series of folds of fabric. To eliminate them, put them in the dryer with a damp cloth and a dryer on the lowest heat. Check off the curtains every few minutes, until the fold line. You can not let the curtains of the dryer for an extended period without checking, as it can get out one way or the melt line permanently.
When the curtains are hot and the fold line is less visible, remove the curtains and the fingers, press the balance of the output line from the top. Then they hang, and all other fold line should be "Fall Out.
Post a Comment